I put in a simple paver surface on the front terrace. I’m really happy with it. The surface is formed from 4″x8″x2-3/8″ Belgard pavers. They are installed upside down, so that the beveled edges intended to be visible on the top are actually hidden on the lower side. That way, I get a nice crisp “brick” look. My contractor was Appian Paver Systems (owner Doug Anthony). He bought 840 sq-ft of material (an even number of pallets) and then just installed it all…allowing the rear terrace to be whatever size it ended up being. That way we got the most area possible for a given cost. These pavers run about $12-14/sq-ft installed, which is more than plain concrete, but about the same as stamped concrete. I much prefer the look to the various concrete alternatives. I also much prefer this surface to that of a wooden deck.
Posts Tagged ‘terrace’
Just one defect emerged in the Park City house over the winter. About half of the main roof drains onto the front awning and then onto the paver terrace. A lot of water hits that terrace, and much of it drains down through the terrace instead of running off the front edge. As a result, the pavers settled a lot over the winter. One of the architects had suggested the possibility of inserting a 12″ c-channel into the paver surface to serve as a gutter from the point where the water hits the terrace to the edge. I wasn’t wild about introducing a 2-3″ groove in the terrace, as I thought it would be a trip hazard. Instead I designed a nifty welded gutter assembly with a slightly sloped top surface which feeds a 3″ c-channel beneath it to drain off the terrace. Hard to explain, but hopefully the pictures are clear.